Vidikron crt spec

 

Specifications

Performance

Features

Value (2001 US Funds)

 VIDIKRON Model

CRT Size

CRT number

Chassis ControlsPeak Lumens

HScan kHz

VScan Hz

RBG Bandwidth Mhz

Screen Size "Max ResolutionHDTV InputsIR RemotePoint ConvergenceEM FocusNew ListRetail UsedWhsle MintWhsle Fair
TGS One5.5-Analog6001650-601060-120480iNVYNN4495521296168
TGS Two5.5-Analog6001650-601060-120480iNVYNN4495713414240
TGS 2005.5-Analog6001650-601060-120480iNVYNN59951391871545
TGS 3005.5-Analog6001650-601060-120480iNVYNN59951532994712
TGS 3015.5-Analog6001650-601060-120480iNV/S/RYNN600023441524990
TGS XP5.5-Analog6001650-601060-120480iNV/S/RYNNN/AN/AN/AN/A
VPF 405.5-Analog6001650-601060-120480iNV/S/RYNN679518021171761
VPF 40GL5.5-Analog6001650-601060-120480iNV/RYNN849517341125730
VPF 40SE5.5-Analog6001650-601060-120480iNV/S/RYNN7495281418291188
VPF 40HD5.5-Digital60015-5445-1205060-3001024x768pYRY-N15995468830471980
VPF 40HDX5.5-Digital60015-5445-1205060-3001024x768pYRY-N15995635841322686
VPH 50HD5.5-Digital60015-6445-1205060-3001280x1024pYV/S/RY-N19995933060643942
VPH 50HDX5.5-Digital60015-6445-1205060-1801280x1024pYV/S/RY-N19995794851663358
Kronos One5.507MPDigital60030-4845-1205060-3001024x768pYRY-N10995700945552961
Vision 38180DMB22Digital100030-11045-15010078-3101600x1200pYV/S/RY45Y2499515933103576732
Vision 28180DMB22Digital120015-15238-18010078-3101600x1200pYV/S/RY45Y320001324886115597
Vision 19P19***Digital130015-15238-18012078-3102500x2000pYV/S/RY45Y4999521989142939290

Additional Information

  Mass Lbs  (Kg)

 Operating Voltage

 Dimensions L x W x H   (mm)

TGS Series

 -

120 VAC 50/60hz-
VPF Series-120 VAC 50/60hz-
Kronos One99Lbs (45kg)120 VAC 50/60hz-
Vision 2/3186 Lbs (84.5kg)120 VAC - 240 VAC 50/60hz38 x 29 x 20 (974 x 744 x 513)
Vision 1195 Lbs (88.6kg)120 VAC - 240 VAC 50/60hz38 x 29 x 20 (974 x 744 x 513)
Glossary of Terms

CRT Size - Although manufacturers measurements will vary, these measurements are ACTUAL tube measurements corner to corner of the projection (raster) area.

Chassis Controls - Analog chassis projectors use manual "pots" for convergence, image sizing, shift, etc.  With the newer digital convergence feature, convergence is done from the control panel or infrared remote control.  This gives you the ability to stand at the screen and more accurately set up the focus and alignment of the CRT's. Digital convergence units also may have memories for different inputs and aspect ratios.  These can then be changed with the push of a button on the remote.

Peak Lumens - Lumens relate to the amount of energy (light) that's coming from the CRT.  It describes the potential of the projector, but little of the actual brightness you will get on screen.  The brightness depends on many factors.  The most important being the screen size and material as well as ambient light conditions. For more information click here.

Scan Rates and HDTV -  The ability of a projector to display HDTV depends on its scanning capability. For example for a projector to line double standard NTSC signals (480i at 15.75khz horizontal) from DVD, VCR or cable/ Satellite  to 480p, requires 31.5 Khz of horizontal scan rate and enough bandwidth to handle twice the picture information. HDTV at 1080i requires a horizontal rate of 33.75 Khz and 50 Mhz bandwidth.  720p requires a horizontal rate of 45 Khz with 50 Mhz bandwidth. 

Inputs - As listed above V = standard composite video, usually a BNC connector on projectors (takes a $2 Radio shack connector to convert back to RCA). S = S-video in its usual form. R = RGB in either a DB type plug or 5 separate RGBHV BNC type connectors. C = Component video.  Any values in ( ) are available with an optional input board.

Point Convergence - A feature of a digital chassis where after doing a rough convergence you can fine tune various areas of the image for a tighter alignment

Electromagnetic Focus - A feature on newer projectors where you not only have the ability to focus corners and center, but additional electronic controls for fine focus of the beam spot throughout various areas of the image.
Value - Pricing based on CRT projector sales during the 2001 year throughout the USA.  Retail is what you can expect to find similar units priced in stores with a limited warranty.  Wholesale mint is the price a store or reseller is paying for a projector with no warranty in generally good to like new condition.  Wholesale fair is the average price that a  reseller is paying for units in average condition.
 

 

 http://digilander.libero.it/iaceavforum/ il Sito di IACE Digiland member

 


 Su