Dreambox DM7025
Reverse Engineering Project

Front Processor:

Here you can see a photo of the frontprocessor (it's located in the bottom right corner of the mainboard):

In order to read and write its firmware you must build a little interface called STK-200, it connects between the parallel port of your pc and the FP (with 4 wires + supply).

Software can be downloaded here: http://www.lancos.com/prog.html

Click to enlarge

Click to enlarge

The STK-200 interface needs 3.3 Volts to run, you can connect on the X1000 2x5 connector near the FP

?	+3.3 V
?	?
?	GND
?	?
?	?

X1000 connector pinout

Then you need to solder 4 wires to the FP programming pins:

Click to enlarge

>> Proceed to next page <<

(c) 2008 by Zabanitu