Luxman L 30

Stereo integrated amplifier (solid state)

FRONT PANEL. Upper line (from left to right) : speakers selector switch (off, main, remote system), left and right treble controls, pilot lamp. Volume, input selector (aux 2, tuner, phono, aux 1). Lower line : power switch, left and right bass controls, low cut filter, high cut filter, loudness, mode selector switch (stereo / mono), tape monitor.

BACK PANEL : ground, tape connector,  main speakers, inputs: aux 1, phono, tuner, aux 2. Tape deck : rec-out, tape monitor. Remote speakers. Extra mains outlet.

SPECIFICATIONS

RMS output power 32 w Per channels  at 8 ohms -  37 w 4 ohms

T.H.D less than 0.05 % ( 8 ohms )

I.M.D les than 0.1 % ( 8 ohms )

Power Bandwidth : 10 – 50 Khz ( -36db 0.1 % )

Frequency response : 15 – 50 Khz (less than  – 1 db )

Input sensitivity :

Phono 2.6 mV

Aux1 : 150 mV

Aux2 : 150 mV

Input impendance :

Phono 5O Kohms

Tuner 60 Kohms

Monitor 60 Kohms

SN Ratio :

Phono more than 64 db

Tuner more than  83 db

Aux 1,2  more than 83 db

Monitor  more than 83 db

Residual noise – 87db

Tone control:  Lux type NF tone control

Filter High cut 7Khz – 6db/ oct

Low cut 70Khz – 6db/oct

Damping factor more than 90 ( 8 ohms )

Power consumption : 140 w

27 transistors,  8 diodes, 2 Zener diodes, 1 LED

Dimensions : 440 mm ( 17-3/8“) W – 160 mm (6-5/16“) H -  225 mm (8-7/8 ») D.

Weight : 7 Kgs (15.4 lbs)

Years  1976-78

Are available on request the service and the owner’s manual.

Is available on request the abstract of testing performed by Italian hi-fi magazine Stereoplay (no.42,1977) 

E' disponibile a richiesta l'estratto della prova tecnica eseguita dalla rivista Stereoplay (n.42,1977)

Back

Torna alla mia collezione hi-fi