|
Garrard MRM-101Music
recovery module
“ The Music Recovery Module (referred
to as MRM) is designed to remove the objectionable noises heard when a
phono pickup meets a scratch on the record being played. The MRM is not
intended to remove all noises associated with old, worn or generally
dirty records. Since these noises occur in an almost continuous manner,
their detection could lead to the removal of a substantial proportion of
the original recording.” "Il Music Recovery Module (denominato MRM) è progettato per rimuovere i rumori sgradevoli quando il fono-pickup in fase di riproduzione incontra un graffio sul disco. Il MRM non è in grado di rimuovere tutti i rumori in dischi usurati o sporchi.Poiché questi rumori si verificano in un modo quasi continuo,la loro neutralizzazione può comportare la rimozione di una parte consistente della registrazione originale. " (estratto dal manuale originale Garrard) FRONT
PANEL : Power switch – Suppressor pilot lamp – Suppressor control
– Suppressor switch REAR
PANEL : DIN phono input – RCA left and right phono inputs – Ground -
RCA left and right outputs -
Fuse “The MRM
contains a high quality stereo pre-amplifier with magnetic phono inputs.
This allows the MRM to be simply and directly connected to the amplifier
'auxiliary' or 'tuner' inputs. The scratch detection circuit recognises
the whole waveform of the scratch and distinguishes it from the peaks of
the recorded music. In order to allow the scratch detection circuit
sufficient time to make the decision to remove the scratch, the channels
are individually delayed by a few milli-seconds without limiting the
audio frequency range. After recognising the scratch, a specially
designed network isolates the signal for sufficient time for the scratch
noise to pass out of the delay line.” “Il Garrard MRM contiene un pre-amplificatore stereo di elevata qualità con ingressi magnetici phono.Questo consente all'MRM di essere di semplice struttura e direttamente collegabile all’ingresso ausiliario (aux) dell’amplificatore o del sintonizzatore. Il circuito di rilevamento del disturbo riconosce tutta la forma d'onda di esso e la distingue dal picco musicale. Al fine di consentire al circuito di individuazione dello “scratch” il tempo sufficiente per prendere la decisione di rimuovere il disturbo, i canali sono ritardati individualmente di qualche milli-secondo, senza limitare la gamma di frequenza audio. Dopo il riconoscimento del segnale anomalo, un dispositivo appositamente progettato isola il segnale per il tempo sufficiente affinché il rumore generato dal graffio possa essere portato fuori dalla linea di ritardo ". (estratto dal manuale originale Garrard)
Is available on request the service manual.
Torna
alla mia collezione hifi |